Our Westminster supply and fit service
Getting FD60 fire doors right in Westminster means choosing a certified doorset for each opening and fitting it exactly as tested. That's the whole service: survey, schedule, certified doorset, careful installation and the paperwork to prove it.
Westminster is about 1 mile from London. Wherever your building is in SW1E, we arrange survey and fitting dates around access and occupancy.
Regulations for FD60 fire doors in Greater London
Fire doors in Westminster sit under English rules: Approved Document B sets what goes in, the Regulatory Reform (Fire Safety) Order 2005 covers keeping doors effective in non-domestic premises and shared parts of residential buildings, and the 2022 regulations require regular door checks in residential buildings taller than 11 metres. Higher-risk buildings — 18 metres or seven storeys with two or more homes — also come under the Building Safety Act 2022.
FD60 fire doors prices in Westminster
Our guide for FD60 fire doors is £1,050–£1,650 per single doorset fitted, ex VAT. Quotes for Westminster are fixed once we've measured, and include removing and disposing of old doors where they're being replaced.
Central and inner London work can cost a little more where parking, loading restrictions or out-of-hours access apply; we show any access costs as a separate line.
Each quote covers the certified doorset, standard ironmongery, fitting, removal of the old door and a handover record; anything outside that scope is shown as a separate line before you accept.
Typical uses in Westminster
Compartment walls and higher-risk stores are among the most common settings for FD60 fire doors, in Westminster as elsewhere.
London has the UK's largest concentration of purpose-built flats and high-rise residential blocks, so flat entrance doors, communal corridor doors and regulation 10 checks drive much of the demand.
- Compartment walls
- Higher-risk stores
- Plant and boiler rooms
- Stair cores in taller blocks
What's in the doorset
| Fire resistance | 60 minutes integrity (FD60 / E60); EI60 where specified |
|---|---|
| Typical leaf | 54mm timber or steel |
| Smoke control | FD60S available with tested smoke seals |
| Typical use | Compartment walls, firefighting shafts, plant rooms |
| Hinges | Usually four hinges on timber leaves, per test evidence |
See the full specification and options for FD60 Fire Doorsets
What happens next
- Send your postcode, door count and any fire risk assessment notes
- We survey and measure each opening for free
- You get a fixed, itemised quote with certificate references
- We fit, test operation and hand over the paperwork
Your questions answered
What does a Westminster quote include?
Survey, certified doorset, ironmongery, installation, removal of old doors and a handover pack. VAT is added at the standard rate.
Will I get certificates for the doors fitted in Westminster?
Every doorset is listed in your handover pack with the manufacturer's certificate reference, plus an installation record and photos.
Do you remove the old doors?
Yes. Removal and disposal of the old door and frame is included when we replace a doorset in Westminster.
Can I use an FD60 door where FD30 is required?
Yes — a higher rating meets a lower requirement — but it is heavier and dearer, so we only recommend it where the location calls for it or you want a margin.
Also covering towns near Westminster
- Pimlico (1 mile)
- London (1 mile)
- Chelsea (2 miles)
- Battersea (2 miles)
- Brixton (2 miles)
- Fulham (3 miles)
Also available in Westminster
- Steel Fire Doors in Westminster
- FD90 & FD120 Doorsets in Westminster
- Fire Door Replacement in Westminster
- Flat Entrance Fire Doors in Westminster
- Security Fire Doors in Westminster
- Fire Door Ironmongery & Closers in Westminster
- Acoustic Fire Doors in Westminster
- Double & Leaf-and-a-Half Fire Doors in Westminster
- FD60 Fire Doorsets across Greater London
- All fire doors in Westminster