Complete certified doorsetsFree measure surveyEngland, Wales, Scotland & NI
Call 0800 088 6248
Fire Rated Doors
FD30SE30 SaSmoke seals

FD30S Smoke Control Doorsets in Maldon

We supply and fit FD30S fire doors in Maldon (CM9) as complete certified doorsets — from free survey to fixed quote, certified doorset and documented installation, all under one price.

From £800 per single doorset in Maldon, supplied & fitted, ex VAT

Close-up of an intumescent strip and brush smoke seal set into a fire door frame

FD30S fire doors in Maldon: how we work

If your fire risk assessment in Maldon has flagged doors to replace, we can schedule, quote and fit FD30S smoke control doorsets for flats, stairs and corridors to match its recommendations. Surveys in CM9 are free and quotes are fixed and itemised.

Maldon is about 14 miles from Southend-on-Sea. Wherever your building is in CM9, we arrange survey and fitting dates around access and occupancy.

Fire door rules in Maldon

In Maldon, as across England, Approved Document B governs new work and the Fire Safety Order 2005 governs existing premises. Note that Approved Document B is removing the BS 476 fire-resistance test references on 2 September 2029, so specifications are moving to EN classifications such as E30 Sa.

Cost of FD30S fire doors in Essex

Guide prices for FD30S fire doors in Maldon run from about £800 to £1,250 per single doorset, supplied and fitted, ex VAT. Size, glazing, finish and ironmongery move the price, and the survey quote is fixed.

Made-to-measure sizes for older openings, vision panels and upgraded hardware are the usual reasons a door sits towards the top of the range.

Where FD30S fire doors are needed

Typical uses for FD30S fire doors in Maldon include lobby doors in blocks of flats and cross-corridor doors.

Essex covers commuter towns, new estates and large town-centre flat developments, from Southend and Basildon to Chelmsford and Colchester.

  • Lobby doors in blocks of flats
  • Cross-corridor doors
  • Integral garage doors
  • Protected stairways

What's in the doorset

Fire resistance30 minutes (FD30 / E30)
Smoke controlTested to BS 476-31.1 or BS EN 1634-3 (Sa)
SealsCombined intumescent and brush or blade smoke seal
Typical useFlat entrances, protected stairs, corridor doors
CloserOverhead or concealed closer to BS EN 1154
Elevation drawing of fd30s smoke control doorsets

See the full specification and options for FD30S Smoke Control Doorsets

From enquiry to handover

  1. Send your postcode, door count and any fire risk assessment notes
  2. We survey and measure each opening for free
  3. You get a fixed, itemised quote with certificate references
  4. We fit, test operation and hand over the paperwork

Questions about FD30S fire doors in Maldon

Can you work around tenants or staff in Maldon?

Yes. We phase work in occupied buildings and keep escape routes available. Each door is planned to be removed and replaced the same day; if that isn't possible, the opening is made secure and we tell you in advance.

Will I get certificates for the doors fitted in Maldon?

Every doorset is listed in your handover pack with the manufacturer's certificate reference, plus an installation record and photos.

Which rules do FD30S fire doors in Maldon need to meet?

They are specified to Approved Document B (England) and your fire risk assessment or fire strategy. We confirm the rating of each door at survey.

What is the difference between FD30 and FD30S?

Both resist fire for 30 minutes. FD30S also has tested smoke seals that limit cold smoke passing around the leaf before the intumescent strip activates.

Also covering towns near Maldon

Other products in Maldon

Get a fixed quote for your fire doors

Free measure survey. Certificate reference against every doorset.