Complete certified doorsetsFree measure surveyEngland, Wales, Scotland & NI
Call 0800 088 6248
Fire Rated Doors
FD30SE30 SaSmoke seals

FD30S Smoke Control Doorsets in Barnet

We supply and fit FD30S fire doors in Barnet (EN5) as complete certified doorsets — with a free measure survey, a fixed itemised quote listing every certificate reference, and installation exactly as tested.

From £800 per single doorset in Barnet, supplied & fitted, ex VAT

Close-up of an intumescent strip and brush smoke seal set into a fire door frame

FD30S Smoke Control Doorsets for Barnet buildings

Fire Rated Doors supplies and fits FD30S fire doors in Barnet, Greater London. Whether it's a single replacement or every door in a block, we start by surveying the openings and end with a handover pack listing each doorset and its certificate reference.

Barnet is about 11 miles from London. Wherever your building is in EN5, we arrange survey and fitting dates around access and occupancy.

Which rules apply in Barnet?

Fire doors in Barnet sit under English rules: Approved Document B sets what goes in, the Regulatory Reform (Fire Safety) Order 2005 covers keeping doors effective in non-domestic premises and shared parts of residential buildings, and the 2022 regulations require regular door checks in residential buildings taller than 11 metres. Higher-risk buildings — 18 metres or seven storeys with two or more homes — also come under the Building Safety Act 2022.

What do FD30S fire doors cost in Barnet?

Our guide price for FD30S fire doors in Barnet is £800 to £1,250 per single doorset including fitting, ex VAT. Non-standard sizes, veneers, vision panels and access control push towards the top of the range.

Central and inner London work can cost a little more where parking, loading restrictions or out-of-hours access apply; we show any access costs as a separate line.

Made-to-measure sizes for older openings, vision panels and upgraded hardware are the usual reasons a door sits towards the top of the range.

Where FD30S fire doors are used in Barnet

In Barnet, FD30S fire doors are typically needed in lobby doors in blocks of flats and integral garage doors.

London has the UK's largest concentration of purpose-built flats and high-rise residential blocks, so flat entrance doors, communal corridor doors and regulation 10 checks drive much of the demand.

  • Lobby doors in blocks of flats
  • Integral garage doors
  • Cross-corridor doors
  • Protected stairways

What's in the doorset

Fire resistance30 minutes (FD30 / E30)
Smoke controlTested to BS 476-31.1 or BS EN 1634-3 (Sa)
SealsCombined intumescent and brush or blade smoke seal
Typical useFlat entrances, protected stairs, corridor doors
CloserOverhead or concealed closer to BS EN 1154
Elevation drawing of fd30s smoke control doorsets

See the full specification and options for FD30S Smoke Control Doorsets

How it works in Barnet

  1. Share your FRA or inspection findings
  2. We confirm every door on site
  3. Fixed quote, certified doorsets only
  4. Fitted to the manufacturer's instructions, with photos

FD30S fire doors in Barnet: questions

Is the survey in Barnet free?

Yes. We measure and schedule your doors at no cost and send a fixed, itemised quote.

Will I get certificates for the doors fitted in Barnet?

Every doorset is listed in your handover pack with the manufacturer's certificate reference, plus an installation record and photos.

Can you work around tenants or staff in Barnet?

Yes. We phase work in occupied buildings and keep escape routes available. Each door is planned to be removed and replaced the same day; if that isn't possible, the opening is made secure and we tell you in advance.

Is a threshold seal needed?

It depends on the doorset's test evidence. Some FD30S doorsets need a drop-down or threshold seal; others control smoke with a set threshold gap.

FD30S Smoke Control Doorsets near Barnet

Other products in Barnet

Get a fixed quote for your fire doors

Free measure survey. Certificate reference against every doorset.