Complete certified doorsetsFree measure surveyEngland, Wales, Scotland & NI
Call 0800 088 6248
Fire Rated Doors
FD30SE30 SaSmoke seals

FD30S Smoke Control Doorsets in Brixton

We supply and fit FD30S fire doors in Brixton (SW9) as complete certified doorsets — surveyed free, quoted door by door with each manufacturer's certificate reference, and fitted to the manufacturer's instructions.

From £800 per single doorset in Brixton, supplied & fitted, ex VAT

Close-up of an intumescent strip and brush smoke seal set into a fire door frame

Getting FD30S fire doors fitted in Brixton

If your fire risk assessment in Brixton has flagged doors to replace, we can schedule, quote and fit FD30S smoke control doorsets for flats, stairs and corridors to match its recommendations. Surveys in SW9 are free and quotes are fixed and itemised.

Brixton is about 3 miles from London; we cover both, along with Peckham, Pimlico and Battersea.

What the law says in Brixton

In Brixton, as across England, Approved Document B governs new work and the Fire Safety Order 2005 governs existing premises. Note that Approved Document B is removing the BS 476 fire-resistance test references on 2 September 2029, so specifications are moving to EN classifications such as E30 Sa.

FD30S fire doors prices in Brixton

Our guide price for FD30S fire doors in Brixton is £800 to £1,250 per single doorset including fitting, ex VAT. Non-standard sizes, veneers, vision panels and access control push towards the top of the range.

Central and inner London work can cost a little more where parking, loading restrictions or out-of-hours access apply; we show any access costs as a separate line.

Made-to-measure sizes for older openings, vision panels and upgraded hardware are the usual reasons a door sits towards the top of the range.

Buildings that need FD30S fire doors

In Brixton, FD30S fire doors are typically needed in lobby doors in blocks of flats and protected stairways.

London has the UK's largest concentration of purpose-built flats and high-rise residential blocks, so flat entrance doors, communal corridor doors and regulation 10 checks drive much of the demand.

  • Lobby doors in blocks of flats
  • Protected stairways
  • Integral garage doors
  • Cross-corridor doors

FD30S Smoke Control Doorsets: key specification

Fire resistance30 minutes (FD30 / E30)
Smoke controlTested to BS 476-31.1 or BS EN 1634-3 (Sa)
SealsCombined intumescent and brush or blade smoke seal
Typical useFlat entrances, protected stairs, corridor doors
CloserOverhead or concealed closer to BS EN 1154
Elevation drawing of fd30s smoke control doorsets

See the full specification and options for FD30S Smoke Control Doorsets

Four steps to compliant doors

  1. Share your FRA or inspection findings
  2. We confirm every door on site
  3. Fixed quote, certified doorsets only
  4. Fitted to the manufacturer's instructions, with photos

FD30S fire doors in Brixton: questions

Is the survey in Brixton free?

Yes. We measure and schedule your doors at no cost and send a fixed, itemised quote.

Do you remove the old doors?

Yes. Removal and disposal of the old door and frame is included when we replace a doorset in Brixton.

Will I get certificates for the doors fitted in Brixton?

Every doorset is listed in your handover pack with the manufacturer's certificate reference, plus an installation record and photos.

Do smoke seals stop the door closing?

They shouldn't. A properly hung FD30S door closes and latches under its closer. If seals are crushed or the door binds, it needs adjusting — a door that fails to latch is a failed fire door.

Also covering towns near Brixton

Other products in Brixton

Get a fixed quote for your fire doors

Free measure survey. Certificate reference against every doorset.